a/arch/arm/mach-kirkwood/sheevaplug-setup. Change to build_dir/linux-kirkwood/linux-2.6.30.10 and apply the following patch: (This step isn't required, but I recommend it for easier recovery from bad flash writes below.) Use "make kernel_menuconfig" to add built-in SCSI disk, USB EHCI, USB storage, and ext2 filesystem support.ģ. Also select built-in luci and ntpclient packages. Add squashfs in the target images section. Use "make menuconfig" to configure the build system for a kirkwood target.
#Dockstar hungary serial
The CA-42 cable has a PL-2303 USB to 3.3v TTL serial adapter in it which provides the required 3.3v TTL and gives an easy to use connector for plugging it into your host PC. interfacing it to a standard +12V/-12V serial port will damage your Dockstar. You need to build your own OpenWrt kernel and root filesystem image, because the Marvell Kirkwood target currently supports only the Sheevaplug, which has a different NAND flash layout. This is required as the dockstar’s serial port voltages are at a 3.3V TTL.
#Dockstar hungary how to
See this page for the serial pinout (and how to open the case) and this page for a picture of where to find the connector.Ģ.
#Dockstar hungary install
Open the case and install a serial cable. No one has tried to restore the factory firmware yet, so we don't know whether that's possible. WARNING: this approach requires you to open the case and install a serial cable, and completely replaces the factory-installed software with OpenWrt. Update: I've consolidated this HOWTO and the following one into a single guide to installing OpenWrt on the Dockstar. On the other hand, if you already have a PC or NAS box tasked for that, you can skip DockStar.This post describes how to install an OpenWrt kernel and rootfs on the internal NAND flash of the Seagate Dockstar so that it will boot into OpenWrt at power-on, with no USB storage device required. DockStar obviates the need for a PC or NAS box dedicated to FTP or HTTP file sharing. Pzmny Pter Catholic University, Budapest, Hungary. The Web interface is easy to use and intuitive and experience in general (other than the wait for files to upload) is pretty cool. PyDockSaxs and HADDOCK CombDock and DockStar the BioMagResBank database as well as BME and. Once you’ve created your account by providing the usual info, you’ll be able to access and share all the files on any of the drives that are attached to the Dockstar via the same Web site you sign up at. The major difference is that you may attach up to four USB drives of any type to the DockStar’s three full-sized USB, and one mini-male USB ports (for the FreeAgent Go). If you thought I was kidding about the PogoPlug reference, consider that its software has a button that actually says Activate Pogoplug. How can i have access to the dockstar again.
Can i install the debian back to the usb disk without getting into the dockstar. Engineering - Research Consultants (Miscellaneous) In Budapest, Infobel has listed 367,249 registered companies. When i boot the dockstar with the debian(usb) attached to it, it blinks green then stops to nothing.
Scientific And Technical Research Organisations. To use it, simply plug in the AC adapter, attach the DockStar to your network via the supplied Ethernet cable, browse to /activatemydockstar and follow the prompts. 27 Gábor Áron utca 1026 Budapest Budapest Megye - Central Hungary - Hungary.
0 kommentar(er)
